Automotive 2.8mm Terminals | In-House Stamped | JDE Auto

Nov 02, 2026

Leave a message

                                        

                     76_clear_compress_pixian_ai.png                           75_clear_compress_pixian_ai.png

H1: Automotive 2.8mm Terminals, Stamped In-House

 

The 2.8mm terminal is the workhorse of automotive wiring. You'll find it in body control modules, lighting harnesses, and power distribution boxes. It's not glamorous, but it has to work-every time, for ten years, in a vehicle that shakes, heats up, and gets wet.

 

We stamp automotive 2.8mm terminals in-house from brass or high-conductivity copper alloy. We don't buy from traders. That's how we control tolerance on the mating geometry.

 

H2: What We Supply

 

2.8mm terminals stamped on in-house progressive dies

 

Brass or high-conductivity copper alloy base material

 

Tin, nickel-under-tin, or gold plating to customer spec

 

Terminals supplied loose or as part of a full harness assembly

 

IATF 16949 quality system behind every lot

 

H2: Crimp Quality Is Where Suppliers Fail Quietly

 

A bad crimp looks fine to the naked eye. Then you pull the wire and it comes out at 80N when it should hold 150N. Or worse, it holds but the resistance is high, and six months later you've got a hot spot and a melted connector.

 

We test crimp pull force on every production lot. For 0.5mm² wire, our minimum is 150N. We also run cross-section analysis on sample crimps to check compression ratio and void percentage.

 

H2: Tolerances That Hold

 

The 2.8mm terminal is a tight part. The mating tab has to engage cleanly, the retention lance has to lock into the housing, and the crimp has to hold the wire without cold joints. We run progressive dies with in-die monitoring to keep the geometry stable shift after shift.

 

H2: FAQ

 

Do you stamp 2.8mm terminals in-house?
Yes. We stamp them on our own progressive dies and plate to customer spec. We don't buy from traders, which is how we control mating geometry tolerance.

 

What's your crimp pull force specification?
Minimum 150N for 0.5mm² wire. We test every production lot and can provide the test data with shipment.

 

Can you supply terminals as part of a harness assembly?
Yes. We supply loose terminals or full harness assemblies, depending on what your line needs.

 

CTA: Send us your terminal drawing and annual volume. We'll quote it and send samples for validation.
Contact JDE Auto: www.jdecontact.com | www.jdeauto.com
 

Send Inquiry